Mismatch Blizzak question

[jpmn3blk]

So I picked up 3 used WS-50 Blizzaks with only 1 winters use on them for $100. They fit my stock steelys perfect for my winter setup. Now my question, you can't find new ws-50's anymore, the new model is ws-60. It has a different tread design. I was hoping I can buy one ws-60 and run it on the rear set.

I know the recommendation is always to run with the same pairs, but what problems will this cause me in the rear?

 

[LASERBLUE135]

I don't think you'd have a problem, especially with winter tires. If you were a road course racer then you might have to be concerned, but for this instance it should be zero problems.

 

[YSOSLO]

I agree completely. You'll never notice a difference.

 

[Z-licious]

You're not AWD so you won't notice slight differences in size on your rear wheels. It's not like they do anything but roll.

 

[dmention7]

As long as you run it on the rear, you should be A-OK. Running it on the front *could* cause some extra wear on the diff, since the wheels would be turning at slightly different speeds whenever you were going in a straight line-- the new tire will be a little larger due to the extra tread depth. And it *might* also cause your ABS to act a little funny since it is looking for differences in wheel speed under braking, and most braking is done by the front wheels.

However on the rear end, i doubt you'd notice much difference at all. Maybe a slight pull to one side when braking under slippery conditions, but I would think that'd be the worst of it.