All in good time it went from "hey this would be cool" to fully done in about 3 hours lolYeah, I'll hold any comments until you paint the PVC, and trim the mounting studs for the lights. lol
But props for DIY!
For most things it's a little too bulky/flimsy/ugly.PVC is an underutilized materiel if if you ask me. You can make a lot of good stuff out of it.
It's not that easy, the cages and the bottom piece on the base are one piece, so they don't just "flip around"Flip the bottom light cages around so the text is right side up. that's gonna drive me crazy otherwise. Props for the build tho.
Flip the bottom light cages around so the text is right side up. that's gonna drive me crazy otherwise. Props for the build tho.
x3This ^ that was bugging me too
are the cages integral to the mounting of said lights? If not, i'd say cut the cage off at where the mount plate and the cage meet, flip it, and epoxy it back.It's not that easy, the cages and the bottom piece on the base are one piece, so they don't just "flip around"
Best bet is to cut the logo, flip it, and re set it. Lot of hassle.
You can't solve all your life's problems with epoxy.are the cages integral to the mounting of said lights? If not, i'd say cut the cage off at where the mount plate and the cage meet, flip it, and epoxy it back.
Right, because duct tape is the fix all for life.You can't solve all your life's problems with epoxy.
... But yes, I think that's what he's going to do.